Datalogic Scanning D8330 Manuel D’Utilisation

POWERSCAN

®

 D8330/M8300 

 

 
The first and last cradles of the chain (the two ends of the bus) must be properly 
terminated. The cradle has an internal terminator that can be selected via jumper. 
For this selection you must open the device. 
 

No Termination 

Static 

Dynamic 

 

 
Static termination works for all network configurations. However, the network is 
always under load even when no data transmission takes place. 
 
Dynamic termination can be used for baud rates at or above 38400 and provides less 
load on the network when idle.