Whirlpool W10388776A-SP Manuel D’Utilisation

Using a 4" (102 mm) clamp, connect vent to exhaust outlet  

in dryer. If connecting to existing vent, make sure vent is 

clean. Dryer vent must fit over dryer exhaust outlet and inside 

exhaust hood. Check that vent is secured to exhaust hood 

with a 4" (102 mm) clamp.

Check that the water faucets are turned on.

Check for leaks around “Y” connector, faucets, and hoses.

One end of the long hose has a wire mesh strainer inside the  

coupling. Attach this end to the “Y” connector. Attach washer 

cold inlet hose to other side of “Y” connector. Screw on 

coupling by hand until it is seated on connector. Using pliers, 

tighten the couplings an additional two-thirds turn.

noTE: Do not overtighten. Damage to the coupling can result.

Attach other end of long hose  

to fill valve at bottom of dryer  

back panel. Screw on coupling  

by hand until it is seated on fill 

valve connector. Using pliers, 

tighten the couplings an additional 

two-thirds turn.

noTE: Do not overtighten. Damage 

to the coupling can result.