ARRI 416 Manuel D’Utilisation

The 416 Lightweight Support LWS-5 is a sturdy, three point 

bracket for mounting 15 mm lightweight support rods. The 

LWS-5 is fitted with an Accessory Rosette to replace the 

camera‘s rosette which is covered when the LWS-5 is 

fitted 

a

.

•  Fit the LWS-5 to the camera by first engaging the two 

guide pins of the upper 3/8-16 screw on the camera 

right side 

a

. This will position the LWS-5 so 

that the 3/8-16 screw on the front of the bracket lines 

up with the threaded hole In the camera. Engage this 

screw by a few threads but leave it loose 

a

.

•  Tighten the two screws on the camera right side – the 

lower one is accessed through a hole in the Accessory 

Rosette teeth 

a

.

•  Tighten the front screw.

•  Slide the support rods into the guides and clamp.

Note: 

Due to the camera‘s small dimensions and because 

the distance from the lens to the support rods is 

fixed, the rod clamps of the LWS-5 project below 

the camera base. To mount the camera with the 

LWS-5 fitted on a support system such as the Steadi-

cam, it is necessary to fit the 416 Riser. This 

presents a flat base, clear of the support rods, 

with selection of threaded holes.

LWS-5

upper screw

rosette

clamp

front screw

clamp

lower screw