Fujifilm FinePix F440 Manuel D’Utilisation

12

13

The viewfinder lamp lights red and battery charging
begins. When charging is completed, the viewfinder
lamp turns off.

h Full recharging times for completely depleted

battery
At an ambient temperature of +21°C to +25°C 
(+70°F to 77°F)
NP-30: approx. 2 hours

●

Charging times increase at low temperatures.

●

If the viewfinder lamp blinks during charging, a charging error
has occurred and the battery cannot be charged. If this
occurs, see P.93.

●

Turning the camera on during charging interrupts the
charging.

Remove the camera from the cradle.

0

1

0

2

1 Plug the AC power adapter connector into the

“DC IN 5V” socket.

2 Plug the AC power adapter into a power outlet.

Check that the camera is turned off. Set the
camera into the cradle.

●

Plug the camera securely into the Cradle connection socket.

Close the battery cover.

◆

◆

Push the xD-Picture Card into the slot and then
slowly remove your finger. The lock is released and
the xD-Picture Card is pushed out.

1 There is ample battery charge. (Only displayed

for 3 seconds when the camera is turned on or
the mode is changed.)

2 The battery is almost half charged. (Only

displayed for 3 seconds when the camera is
turned on or the mode is changed.)

3 There is insufficient charge left in the battery. The

battery will soon run out. Have a new battery ready.

4 The battery is depleted. The display will shortly

go blank and the camera will stop working.
Replace or recharge the battery.

1

2

3

4

Turn the camera on and check whether the battery level warning (

X

, 

C

or 

V

) appears on the

LCD monitor.

●

Battery with no remaining charge (“

V

” blinking red) may

cause camera faults such as the camera turning itself off
without retracting the lens. Always load a new or fully
charged battery.

“

Z

”, “

X

” or “

C

” appears as a small icon on

the right-hand side of the LCD monitor.

●

Depending on the camera mode used, the transition from
“

X

” to “

V

” may occur more quickly.

●

Due to the nature of the battery, the battery level warning
may appear early when the camera is used in cold locations.
This is normal. Try warming the battery in your pocket or a
similar location before use.

“

V

” appears as a large icon on the LCD monitor.

◆

◆

When this function is active, it also turns off the LCD monitor (sleep mode) to reduce power
consumption if the camera is not used for 60 seconds (

➡P.62). If the camera is then left unused for 2 or

5 minutes, the Power save function turns the camera off. To turn camera back on, slide the Power
switch to turn the camera off briefly and then turn it back on.