Fujifilm S5 Pro Manuel Du Propriétaire

Page de 244
80
Flash Photography
MEMO
• If the d flash-ready indicator blinks for about three 
seconds after the photograph is taken, the flash has 
fired at full output and the photograph may be 
underexposed. Check the results in the monitor. If the 
photograph is underexposed, adjust settings and try 
again.
• If the built-in flash is used in continuous shooting mode, 
only one photograph will be taken each time the shutter 
button is pressed.
• Vibration reduction (available with VR lenses) does not 
take effect if the shutter button is pressed halfway while 
the built-in flash is recharging.
• After the built-in flash has been used for several 
consecutive shots, it may turn off briefly to protect the 
flash. The built-in flash can be used again after a short 
pause.
• The built-in flash and Nikon SB-800, SB-600, and SB-
R200 Speedlights emit a modeling flash when the 
camera depth-of-field preview button is pressed. 
Modeling illumination can be turned off by selecting 
[OFF] for the [MODELING FLASH] (
➝p.165) under [
 
FLASH/BKT] in the [SET UP] menu.
To close the built-in flash
To save battery power when the built-in flash is not in use, 
return it to the closed position by pressing it lightly downward 
until the latch clicks into place.
The shutter speeds and apertures available when 
the built-in flash is raised
*
1
Regardless of option selected, camera may set shutter 
to speeds as slow as 30 s at flash sync settings of slow 
sync, slow rear-curtain sync, and slow sync with red-
eye reduction. 
*
2
Speeds faster than 1/250s will be reduced to 1/250s 
when built-in flash is popped up.
*
3
Flash range varies with ISO sensitivity and aperture.  
Consult table of flash of flash ranges (
➝p.81) when 
setting aperture in 
 and 
 modes.
Exposure 
mode
Shutter speed
Aperture
 (
➝p.70)
Set automatically by 
camera (1/250-1/60s)
*1
Set automatically 
by camera
 (
➝p.72)
Value selected by user 
(1/250–30 s)
 *2
 (
➝p.73)
Set automatically by 
camera (1/250-1/60s)
 *1
Value selected by 
user 
*3
 (
➝p.74)
Value selected by user 
(1/250–30 s)
 *2