Fujifilm 16395586 Manuel D’Utilisation

For Your Safety

This product complies with the following EU Directives:
•  Low Voltage Directive 2006/95/EC
•  EMC Directive 2004/108/EC
•  R & TTE Directive 1999/5/EC

Compliance with these directives implies conformity to applicable harmonized European 
standards (European Norms) which are listed on the EU Declaration of Conformity issued by 
FUJIFILM Corporation for this product or product family.

This compliance is indicated by the following conformity marking placed on the product:

This marking is valid for non-Telecom products and EU harmonized Telecom products (e.g. 
Bluetooth).

Regarding the Declaration of Conformity, visit http://www.fujifilm.com/products/digital_
cameras/x/fujifilm_x_a1/pdf/index/fujifilm_x_a1_cod.pdf.

IMPORTANT:  Read the following notices before using the camera’s built-in wireless 
transmitter.

 

Q This product, which contains encryption function developed in the United States, is con-

trolled by the United States Export Administration Regulations and may not be exported 
or re-exported to any country to which the United States embargoes goods.

•  Use only as part of a wireless network.  FUJIFILM does not accept liability for damages result-

ing from unauthorized use.  Do not use in applications requiring a high degree of reliability, 
for example in medical devices or other systems that may directly or indirectly impact 
human life.  When using the device in computer and other systems that demand a greater 
degree of reliability than wireless networks, be sure to take all necessary precautions to 
ensure safety and prevent malfunction.

•  Use only in the country in which the device was purchased.  This device conforms to regulations 

governing wireless network devices in the country in which it was purchased.  Observe all 
location regulations when using the device.  FUJIFILM does not accept liability for prob-
lems arising from use in other jurisdictions.

•  Wireless data (images) may be intercepted by third parties.  The security of data transmitted 

over wireless networks is not guaranteed.

•  Do not use the device in locations subject to magnetic fi elds, static electricity, or radio interference.  

Do not use the transmitter in the vicinity of microwave ovens or in other locations subject 
to magnetic fi elds, static electricity, or radio interference that may prevent reception of 
wireless signals.  Mutual interference may occur when the transmitter is used in the vicinity 
of other wireless devices operating in the 2.4 GHz band.

•  The wireless transmitter operates in the 2.4 GHz band using DSSS and OFDM modulation.

•  This device operates on the same frequency as commercial, educational, and medical devices and 

wireless transmitters.  It also operates on the same frequency as licensed transmitters and 
special unlicensed low-voltage transmitters used in RFID tracking systems for assembly 
lines and in other similar applications.

•  To prevent interference with the above devices, observe the following precautions.  Confi rm that 

the RFID transmitter is not in operation before using this device.  Should you observe that 
the device causes interference in licensed transmitters used for RFID tracking, immediately 
choose a new operating frequency for this device to prevent additional interference.  If you 
notice that this device causes interference in low-voltage RFID tracing systems, contact a 
FUJIFILM representative.

2.4DS/OF4

This sticker indicates that this device operates in the 2.4  GHz 
band using DSSS and OFDM modulation and may cause inter-
ference at distances of up to 40 m.