Fujifilm 16317405 Manuel D’Utilisation

For Your Safety

•  Do not mix old and new batteries, batteries 

with different charge levels, or batteries of 
different types.

• If the camera will not be used for an 

extended period, remove the batteries. 

 

Note that the camera clock will be reset.

• The batteries may be warm to the touch 

immediately after use.  Turn the camera 
off and allow the batteries to cool before 
handling.

• Battery capacity tends to decrease at low 

temperatures.  Keep spare batteries in a 
pocket or other warm place and exchange 
as necessary.  Cold batteries may recover 
some of their charge when warmed.

•  Fingerprints and other stains on the battery 

terminals can impair battery performance.  
Thoroughly clean the terminals with a 
soft, dry cloth before inserting them in the 
camera.

If the batteries leak, clean the battery 
compartment thoroughly before 
inserting new batteries.

If fluid from the battery comes into 
contact with skin or clothing, flush 
the affected area with water.  If fluid 
enters your eyes, immediately flush 
the affected area with water and seek 
medical attention.  Do not rub your eyes.  
Failure to observe this precaution could 
result in permanent visual impairment.

■ NiMH Batteries
The capacity of Ni-MH batteries may be 
temporarily reduced when new, after long 
periods of disuse, or if they are repeatedly 
recharged before being fully discharged. 

 

This is normal and does not indicate a 
malfunction.  Capacity can be increased by 
repeatedly discharging the batteries using 
the discharge option in the camera setup 
menu and recharging them using a battery 
charger.

 

Q CAUTION: Do not use the discharge option 

with alkaline batteries.

The camera draws a small amount of current 
even when off.  Ni-MH batteries that have 
been left in the camera for an extended 
period may be drawn down to the point 
that they no longer hold a charge.  Battery 
performance may also drop if the batteries 
are run down in a device such as a flashlight.  
Use the discharge option in the camera setup 
menu to discharge Ni-MH batteries.  Batteries 
that no longer hold a charge even after 
repeatedly being discharged and recharged 
have reached the end of their service life and 
must be replaced.

Ni-MH batteries can be recharged in a battery 
charger (sold separately).  Batteries may 
become warm to the touch after charging.  
Refer to the instructions provided with 
the charger for more information.  Use the 
charger with compatible batteries only.

Ni-MH batteries gradually lose their charge 
when not in use.

■ Disposal
CAUTION: Dispose of used batteries in accord 
with local regulations.

This section applies to all camera models.  
Use only FUJIFILM AC power adapters 
designated for use with this camera.  Other 
adapters could damage the camera.
•  The AC power adapter is for indoor use only.
• Be sure the DC plug is securely connected 

to the camera.

• Turn the camera off before disconnecting 

the adapter.  Disconnect the adapter by the 
plug, not the cable.

•  Do not use with other devices.
•  Do not disassemble.
•  Do not expose to high heat and humidity.
•  Do not subject to strong physical shocks.
•  The adapter may hum or become hot to the 

touch during use.  This is normal.

• If the adapter causes radio interference, 

reorient or relocate the receiving antenna.