Fujifilm 2800 Zoom Manuel D’Utilisation

Can’t use the flash to
take pictures.

i The flash is set to Suppressed Flash

mode.

i You pressed the shutter button while the

flash was charging.

i The battery is exhausted.

i Set the flash to Auto, Red-Eye Reduction

or Forced Flash mode.

i Wait until charging is completed before

pressing the shutter button.

i Replace the batteries.

The playback image is
too dark even though
the flash was used.

i The subject is too far away.
i Your fingers are obscuring the flash or

flash control sensor.

i Move closer to the subject.
i Hold the camera correctly.

The image is blurred.

i The lens is dirty.
i The lens is zoomed to telephoto in Macro

mode.

i The photographed subject was too dark.

i Clean the lens.
i Cancel Macro mode.

i Try standing about 2 m (6.6 ft.) from your

subject to take the picture.

There is speckling on
the image.

i The shot was taken with a slow shutter

speed (long exposure) in a high-
temperature environment.

i This is a characteristic of CCDs and

does not indicate a camera fault.

I can’t format the
SmartMedia.

i The SmartMedia is write-protected.

i Remove the write-protection.

Peel off the write-protect sticker)

The playback image is
faded when I used the
flash to take a picture.

i There is dust on the flash control sensor.

i Use an applicator such as a cotton swab

to clean the flash control sensor.

eIf you think the camera is faulty, check the following once more

No power.

i The battery is exhausted.
i The AC power adapter plug has come out

of the power outlet.

i Replace the batteries.
i Plug the adapter back in.

Power cuts out during
operation.

i The battery is exhausted.

i Replace the batteries.

Battery runs out quickly.

i You are using the camera in extremely

cold conditions.

i The terminals are soiled.

i The battery is flat.

i Put the battery in your pocket or another

warm place to heat it and then load it into
the camera just before you take a picture.

i Wipe the battery terminals with a clean,

dry cloth.

i Replace the batteries.

No photograph is taken
when the shutter button
is pressed.

i No SmartMedia is loaded.
i The SmartMedia is fully recorded.

i The SmartMedia is write-protected.
i The SmartMedia is not formatted.
i The SmartMedia contact area is soiled.

i The SmartMedia is damaged.
i The Power Save function has switched

the camera off.

i The battery is exhausted.

i Load a SmartMedia.
i Insert a new SmartMedia or erase some

unwanted frames.

i Remove the write-protection.
i Format the SmartMedia.
i Wipe the SmartMedia contact area with

a clean dry cloth.

i Load a new SmartMedia.
i Switch the camera on.

i Replace the batteries.