Roberts Gorden BH-150 Manuel D’Utilisation
SECTION 1: H
EATER
S
AFETY
1
SECTION 1: HEATER SAFETY
Your Safety is Important to Us!
This symbol is used throughout the
manual to notify you of possible fire,
electrical or burn hazards. Please pay
special attention when reading and
following the warnings in these
sections.
This symbol is used throughout the
manual to notify you of possible fire,
electrical or burn hazards. Please pay
special attention when reading and
following the warnings in these
sections.
Installation, service and annual inspection of heater must
be done by a contractor qualified in the installation and
service of gas-fired heating equipment.
Read this manual carefully before installation, operation or
service of this equipment.
This heater is designed for heating nonresidential indoor
spaces. Do not install in residential spaces. These
instructions, the layout drawing, local codes and
ordinances, and applicable standards that apply to gas
piping, electrical wiring, venting, etc. must be thoroughly
understood before proceeding with the installation.
Protective gear is to be worn during installation, operation
and service. Thin sheet metal parts, such as the reflector
portion of the heater and the various venting components,
have sharp edges. To prevent injury, the use of work
gloves is recommended. The use of gloves will also
be done by a contractor qualified in the installation and
service of gas-fired heating equipment.
Read this manual carefully before installation, operation or
service of this equipment.
This heater is designed for heating nonresidential indoor
spaces. Do not install in residential spaces. These
instructions, the layout drawing, local codes and
ordinances, and applicable standards that apply to gas
piping, electrical wiring, venting, etc. must be thoroughly
understood before proceeding with the installation.
Protective gear is to be worn during installation, operation
and service. Thin sheet metal parts, such as the reflector
portion of the heater and the various venting components,
have sharp edges. To prevent injury, the use of work
gloves is recommended. The use of gloves will also
prevent the transfer of body oils from the hands to the
surface of the reflector.
Before installation, check that local distribution conditions,
nature of gas and pressure, and adjustment of the
appliance are compatible.
surface of the reflector.
Before installation, check that local distribution conditions,
nature of gas and pressure, and adjustment of the
appliance are compatible.
For additional copies of the GORDONRAY
®
BH
Installation, Operation and Service Manual, please contact
Roberts-Gordon LLC.
Roberts-Gordon LLC.
1.1 Manpower Requirements
To prevent personal injury and damage to the heater, two
persons will be required for installation.
To prevent personal injury and damage to the heater, two
persons will be required for installation.
1.2 Safety Labels and Their Placement
Product safety signs or labels should be replaced by the
product user when they are no longer legible. Please
contact Roberts-Gordon or your ROBERTS GORDON
Product safety signs or labels should be replaced by the
product user when they are no longer legible. Please
contact Roberts-Gordon or your ROBERTS GORDON
®
independent distributor to obtain replacement signs or
labels.
labels.
See Page 1, Figure 1through Page 2, Figure 2
.
FIGURE 1: Top and Bottom Panel Label Placement
Logo Label
Vent Length Label
Top Panel
Bottom Panel
Gas Connection Label
Description
Part Number
Logo Label
91031100
Vent Length Label
91039500
Gas Connection Label
91018123