Hearth & Home Technologies Tucson (8700) Manuel D’Utilisation

HearthStone Quality Home Heating Products Inc

                                                                   Tucson 

Model #8700

 

 

29

Once connected to the gas supply, the 
supply line and manifold gas pressures must 
be tested. The supply line pressure is tested, 
to insure it meets the minimum gas supply 
pressure as listed in the Specifications for 
the type of fuel in use (natural gas or LP), by 
connecting a manometer to the supply line 
and adjusting the incoming pressure if 
necessary to meet the required supply line 
pressure as listed in specifications. The 
manifold pressure tap on the gas control 
valve, refer to Figure 20 for location. 

CAUTION: Fragile!   Handle log set with 
care. Always wear gloves and safety goggles 
while handling the log set. 
 
Only the  decorative ceramic fiber log set 
supplied with the unit should be placed in 
the firebox. Do not place any other ceramic 
logs, wood logs, or other materials in the 
firebox.  If the log set is damaged or broken 
contact your dealer for replacement.  The 
decorative ceramic fiber log set will last a 
long time, however, they will break if 
subjected to rough or improper handling. 
Exact positioning of the log set is required in 
order to obtain a pleasing flame pattern and 
efficient combustion.  Incorrect log 
placement may cause carbon build-up; 
excess thermal stress on the log set and 
stove parts, reduced efficiency, and high 
levels of carbon monoxide. If the log set 
does not set into the firebox exactly as 
outlined, contact your dealer for assistance. 

(Refer to figures 21 & 22 for log set 
assembly) 
 

1.  Open the front door using a 1/8” 

allen wrench. Loosen the bolt that 
fastens the doorknob to the door. It 
also unfastens the door from the 

firebox by turning it 
counterclockwise. Be careful not to 
chip the enamel when loosening the 
bolt. Pull the door open by grabbing 
the top edge of the door frame. 

2.  Remove the packaging material 

around the log set assembly. Be 
careful not to damage the log set 
when unpacking. 

3.  Gently place the Main Log (1) in the 

firebox against the center of the back 
wall. 

4.  Gently place the Top Log (2) on top 

of the Main Log (1), inserting the 
posts into the holes in  the bottom 
side of the Top Twig. 

5.  Spread evenly across the Ember 

Screens, one layer high, the 2 ounces 
of Charcoal Embers . You will not 
need to use all of the Charcoal 
Embers. Keep the rest to use in the 
future. 

6.  With a 1/8” allen wrench, use the 

bolt to fasten the door to the firebox. 
Make sure the door and knob are 
properly secured to the firebox 
before turning the  unit on. Be careful 
not to chip the enamel when 
fastening the door. 

 
             

 

 

Sediment Trap