Hearth & Home Technologies GBI25 Manuel D’Utilisation

02-02

26678 Rev H

GBI25 SERIES B-VENT GAS FIRED FIREPLACE INSERT

1. OPERATION PROCEDURE DURING

REGULAR USE

Turn the switch/thermostat to the ON position. This

will ignite the main burner.

2. SHUTDOWN DURING REGULAR USE

Simply turn the switch/thermotat to OFF. This will

disengage the burner and the flames will extinguish.

3. SEASONAL SHUTDOWN

When the burning season comes to an end, the entire

system should be shut down to prevent gas running

to the appliance while it is not in use.

4. FAN OPERATION

The fan control is located behind the control access

panel. Lift the panel up and rotate forward. Locate the

fan control knob and turn. See Figure 18. Close the

control access panel.

5. CHECKING FLAME PATTERNS

Check the flame pattern of the burner periodically,

making sure the flames are steady, not lifting or

floating. The flame color should be blue with yellow

tips. The thermopile tip should be covered with flame.

See Figures 26 and 27.

If the vent configuration is installed incorrectly, the vent

may cause the flames inside the appliance to lift or

ghost - a dangerous situation. Inspect the flames

after installation to ensure proper performance. If the

vent configuration is correct, yet the flames are lifting

or ghosting, shut off gas to the appliance and contact

the dealer for information on remedying the problem.

Note:

If the air shutter is open all the way and the flames

remain sooty, shut off gas to the appliance and contact

a qualified service technician.

WARNING!

Children and adults should be alerted to the hazards

of high surface temperatures and should stay away

to avoid burns or clothing ignition. Young children

should be carefully supervised when they are in the

same room as the appliance.

Figure 26 - Standing Pilot

Figure 27 - Flame Patterns