Roland CD-2 Manuel D’Utilisation
19
Checking and Preparations
Attaching the Card Protector
You can attach the included card protector in front of the CF card slot to block the slot and prevent theft of the CF
card.
card.
To attach the card protector, proceed as follows.
1
Turn off the CD-2 and all connected equipment.
• Disconnect all cables from the CD-2.
2
Turn the CD-2 upside down, and remove the card
protector.
protector.
Use a Philips (+) screwdriver to remove the two
screws shown in the illustration.
screws shown in the illustration.
Pull out the card protector in the direction
indicated by the arrow.
indicated by the arrow.
3
Position the card protector as shown in the
illustration, and fasten it in place using the two
screws you removed in Step 2 -
illustration, and fasten it in place using the two
screws you removed in Step 2 -
.
4
Turn the CD-2 right side up.
Card protector
1
2
1
NOTE
When turning the CD-2 upside
down, place stacks of newspapers
or magazines to support the four
corners (or two sides) so that
stress is not placed on the buttons
or knobs, possibly damaging
them. Then, carefully position the
CD-2 in such a way that its
buttons and knobs won’t get
damaged.
down, place stacks of newspapers
or magazines to support the four
corners (or two sides) so that
stress is not placed on the buttons
or knobs, possibly damaging
them. Then, carefully position the
CD-2 in such a way that its
buttons and knobs won’t get
damaged.
Handle the CD-2 with care, and
avoid dropping it.
avoid dropping it.
MEMO
If you’re not using the card
protector
protector
To prevent the card protector
from being lost, leave it fastened
in its original location (shown in
the illustration for Step 2).
from being lost, leave it fastened
in its original location (shown in
the illustration for Step 2).
MEMO
Don’t overtighten the screws,
since this may strip the threads
and even damage the CD-2.
since this may strip the threads
and even damage the CD-2.
Media That Can Be Used with the CD-2 (continued)