Philips AZ1080/00 Manuel D’Utilisation

English

If a fault occurs, first check the points listed below before taking the set for repair. Do
not open the set as there is a risk of electric shock.

If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.

WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee.

Troubleshooting

Problem

Solution

No sound

– Adjust the VOLUME

No power

– Mains lead not securely connected.
Connect AC mains lead properly
– Batteries exhausted /incorrectly inserted.
Insert (fresh) batteries correctly

Display does not function

– Electrostatic discharge

properly/ No reaction to

Switch off and unplug the set. Reconnect after a few

operation of any of the

seconds.

controls

Er indication

– No CD inserted, insert a CD
– CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)
– CD-R(W) is blank or the disc is not finalized.
Use a finalized CD-R(W)
– Laser lens steamed up.
Wait until lens has cleared/acclimatized

CD playback does not work

– CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)

The CD skips tracks

– CD damaged or dirty. Replace or clean CD.
– Shuffle is active. Quit shuffle mode

Poor cassette sound quality

– Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
– Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording

Recording does not work

– Cassette tab(s) may be broken. Apply a piece of
adhesive tape over the missing tab space.

AZ1080/00A 03/13/02 10:06 Page 13