Alpine alpine Manuel D’Utilisation

 

ALPINE PDR-V75 68-25285Z56-A (EN/FR/ES)

Due to the high power output of the PDR-V75 
considerable heat is produced when the amplifier 
is in operation. For this reason, the amplifier should 
be mounted in a location which will allow for free 
circulation of air, such as inside the trunk. For 
alternate installation locations, please contact your 
authorized Alpine dealer.

1.  Remove the hexagon screws using the supplied 

Hexagon Wrench (small). (Fig. 1)

Hexagon Screws

2.  Slide the Top Cover, and lift it to remove. (Fig. 2)

•  Be sure not to damage the indicator area.

Top Cover

3.  Using the amplifier as a template, mark the four 

screw locations.

4.  Make sure there are no objects behind the 

surface that may become damaged during 
drilling.

5.  Drill the screw holes.

6.  Position the PDR-V75 over the screw holes, and 

secure with four self-tapping screws. (Fig. 3)

Self-Tapping Screws (M4 × 20)

Holes

Holes

Chassis

Ground Lead

NOTE:
•  To securely connect the ground lead, use an 

already installed screw on a metal part of the 
vehicle (marked ( )) or a clean, bare metal spot 
on the vehicle’s chassis. Be sure this is a good 
ground by checking continuity to the battery (–) 
terminal. Connect all equipment to the same 
ground point while keeping wire length as short 
as possible. These procedures will help eliminate 
noise.

und to 

ing 
s in 

pment 

y, and it 

ordance 

nit in 

e is 

anty, 

which 

d States 

r dealer 

ge.

..............4
......1 SET
..............1