Jensen VM9414 Manuel D’Utilisation

3

MUTE

NAV

Complete wiring as illustrated in the wiring diagram on page 4. Once the wiring is complete, reconnect the bat-
tery negative terminal. If there is no ACC available, connect the ACC lead to the power supply with a switch.

After completing the wiring connections, turn the unit on to confi rm operation (ignition switch must be on). If 
unit does not operate, recheck all wiring until problem is corrected. Once proper operation is achieved, turn off 
the ignition switch and proceed with fi nal mounting of the chassis.

  Connect wiring adapter to existing wiring harness.

  Connect antenna lead.

  Carefully slide the radio into the mounting sleeve, making  

 

sure it is right-side-up, and secure with the original 4 screws.

  Attach one end of the perforated support strap (supplied) to  

 

the screw stud, which is screwed into the threaded insert on  

 

the back of the unit, using the hex nut provided. Fasten the  

 

other end of the perforated strap to a secure part of the  

 

dashboard either above or below the radio using the screw  

 

and hex nut provided. Bend the strap to position it as 

 necessary. 

  Replace any items you removed from the dashboard.

  Remove mounting sleeve brackets.

  Remove trim ring.

  Mount factory brackets on new radio using existing screws  

 

from old radio.

  Slide radio chassis into dash opening and secure.

  Re-install dash panel.

MUTE

NAV