Husqvarna FC2145S Manuel D’Utilisation

18 – English

spanner with a shaft that is long enough to allow this. The 
arrow in the diagram shows the area where you should 
operate the socket spanner when loosening or tightening 
the nut.

•

Fit the correct trimmer guard (A) for use with the 
trimmer head. Hang the trimmer guard/combination 
guard (A) on the two hooks on the plate holder (M). 
Bend the guard around the shaft and tighten it with the 
bolt (L) on the opposite side of the shaft. Use the 
locking pin (C). Place the locking pin in the groove on 
the screw head and tighten. See diagram.

•

Fit the drive disc (B) on the output shaft.

•

Centre the metal cup (P) on the drive disc’s blade 
guide.

•

Turn the blade shaft until one of the holes in the drive 
disc aligns with the corresponding hole in the gear 
housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

Screw on the trimmer head (H) in the opposite 
direction to the direction of rotation.

•

Tighten the trimmer head to a torque of 35-50 Nm 
(3.5-5 kpm).

•

To dismantle, follow the instructions in the reverse 
order.

•

Fit the trimmer guard/combination guard (A) intended 
for use with the trimmer head/plastic blades. Hang the 
trimmer guard/combination guard (A) on the two 
hooks on the plate holder (M). Bend the guard around 
the shaft and tighten it with the bolt (L) on the opposite 
side of the shaft. Use the locking pin (C). Place the 
locking pin in the groove on the screw head and 
tighten. See diagram.

•

Fit the drive disc (B) on the output shaft.

•

Centre the metal cup (P) on the drive disc’s blade 
guide.

•

Turn the blade shaft until one of the holes in the drive 
disc aligns with the corresponding hole in the gear 
housing.

•

Insert the locking pin (C) in the hole to lock the shaft.