Exmark 4500-367 Manuel D’Utilisation
Maintenance
loose enough to be moved comfortably by the
operator.
operator.
Figure 15
1.
Speed Control Lever
3.
Spring disc washers
2.
Friction Plate
4.
Hex locknut
Speed Control Linkage
Adjustment
Adjustment
WARNING
Engine must be running and drive
wheels must be turning so motion control
adjustment can be performed. Contact with
moving parts or hot surfaces may cause
personal injury.
wheels must be turning so motion control
adjustment can be performed. Contact with
moving parts or hot surfaces may cause
personal injury.
Keep fingers, hands, and clothing clear of
rotating components and hot surfaces.
rotating components and hot surfaces.
CAUTION
Raising the mower deck for service or
maintenance relying solely on mechanical
or hydraulic jacks could be dangerous. The
mechanical or hydraulic jacks may not be
enough support or may malfunction allowing
the unit to fall, which could cause injury.
maintenance relying solely on mechanical
or hydraulic jacks could be dangerous. The
mechanical or hydraulic jacks may not be
enough support or may malfunction allowing
the unit to fall, which could cause injury.
Do Not rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands
or equivalent support.
jacks for support. Use adequate jack stands
or equivalent support.
•
Adjust steering levers
1. Stop engine and wait for all moving parts to
1. Stop engine and wait for all moving parts to
stop.
2. Pull the speed control lever completely back to
the neutral position. The two steering levers
should be straight up and down (vertical). If
necessary, adjust steering levers by changing
the length of the link between the speed
control lever and the control arm on the end
of the steering control shaft (see Figure 16).
should be straight up and down (vertical). If
necessary, adjust steering levers by changing
the length of the link between the speed
control lever and the control arm on the end
of the steering control shaft (see Figure 16).
Figure 16
1.
Loosen jam nuts here to
adjust linkage
adjust linkage
2.
Steering levers should
be vertical
be vertical
•
Set neutral:
1. Remove the electrical connection from the
1. Remove the electrical connection from the
seat safety switch, located directly in front of
the seat switch assembly.
the seat switch assembly.
2. The neutral adjustment must be made with
the drive wheels turning. Raise the frame and
place on jack stands so that drive wheels can
rotate freely. Temporarily install a jumper wire
place on jack stands so that drive wheels can
rotate freely. Temporarily install a jumper wire
31