Behringer Pro Mixer DJX750 Manuel D’Utilisation

PRO MIXER DJX750 User Manual

(42) 

The DJX750 features an integrated effects loop for the connection of an 

external effects device. The MONITOR signal is taken at the SEND output 

and routed, for example, to a reverb processor. Thus, the signal at the SEND 

connector is identical to the headphones signal and is selected with the 

MONITOR CUE buttons  

(16)

.

(43) 

The externally processed signal is added to the MASTER output signal via the 

RETURN connectors. The effect signal volume may only be adjusted at the 

output control of the effects device itself.

(44) 

The MASTER output is for connecting to an amplifier and can be adjusted 

with the MASTER fader  

(18)

.

(45) 

The BOOTH output gives you an additional option of connecting an amplifier 

in order to, for example, feed the signal into your monitors or to bring sound 

to an extra area. The BOOTH output level is regulated by using the BOOTH 

LEVEL control  

(20)

  of the MASTER section.

(46) 

Using the TAPE output you can record your music by connecting devices such as 

tape decks, DAT recorders etc. Unlike the MASTER output, the output volume is 

fixed, making it necessary for you to adjust the input level on the recording device.

(47) 

The POWER switch powers the DJX750 on. You should always make sure that 

the POWER switch is in the “Off” position when initially connecting the unit 

to the mains.

(48) 

This is the connector for the power cable. This is where the advantage of a 

sophisticated internal power supply can be seen: the pulse behaviour of each 

amplifying circuit is mainly determined by the voltage reserves available. 

Each mixing console is equipped with numerous operational amplifiers 

(op amps) to process line level signals. Due to limited output of their power 

supplies, many mixing consoles show signs of “stress” when subjected to 

heavy loads. But not your DJX750: the sound is always clear and transparent.

(49) 

FUSE HOLDER / VOLTAGE SETTING. Before connecting the unit to the mains, 

ensure that the voltage setting matches your local voltage. Blown fuses 

should only be replaced by a fuse of the same type and rating. On some 

units, the fuses holder can be switched to one of two positions, i.e. 230 V and 

120 V. Please note: should you desire to operate the unit outside Europe at 

120 V, a higher fuse rating is required.

(50) 

SERIAL NUMBER.

!

!

Please note that when operating the unit at 120 V, a higher fuse rating is 

required. Please refer to the “Specifications” for details. 
If you set the unit to a different mains voltage, be sure to  use a fuse of the correct 

type and rating. Please refer to the “Specifications” for details.

The mains connection is made using the enclosed power cord and a standard IEC 

receptacle. It meets all international safety certification requirements.

Should your BEHRINGER product malfunction, it is our intention to have it 

repaired as quickly as possible. To arrange for warranty service, please contact 

the BEHRINGER retailer from whom the equipment was purchased. Should your 

BEHRINGER dealer not be located in your vicinity, you may directly contact one of 

our subsidiaries. 
Corresponding contact information is included in the original equipment 

packaging (Global Contact Information/European Contact Information). 

Should your country not be listed, please contact the distributor nearest 

you. A list of distributors can be found in the support area of our website 

(behringer.com). 
Registering your purchase and equipment with us helps us process your repair 

claims more quickly and efficiently. 
Your product was carefully packed at the factory to ensure safe transport. 

Nevertheless, if the box is damaged inspect the unit immediately for signs 

of damage.

Please register your new BEHRINGER equipment right after your purchase 

by visiting behringer.com and read the terms and conditions of our 

warranty carefully. 

Thank you for your cooperation!