Pentax R-315(N) Manuel D’Utilisation
61
8 INITIAL SETTING
8-10 Initial Setting 5
1. Selection of Transfer rate (baud rate) : [BAUD UNIT]
Select a baud rate of 1200, 2400, 4800, or 9600.
2. Selection of Data bits : [DATA LENGTH]
Select a data length of 8 bits or 7 bits.
3. Selection of Parity : [PARITY BITS]
Select no (NIL) parity bit, even parity, or odd parity.
4. Selection of Stop bit : [STOP BITS]
Select the number of stop bits to be used: 1 or 2.
5. Selection of Control signal : [SIGNAL CONTROL]
Select whether the control signal is effective or not.
6. Selection of XON/XOFF : [XON/XOFF]
Select whether to enable or disable XON/XOFF.
7. Selection of Through command : [THROUGH
COMMAND]
Select whether to disable data output without receiving
any data request command or enable the “a” to “f”
command data output.
Select whether to disable data output without receiving
any data request command or enable the “a” to “f”
command data output.
1. 1200
2. 2400
3. 4800
4. 9600
1. 8
2. 7
1. NIL
2. EVEN
3. ODD
1. 1
2. 2
1. ON
2. OFF
1. ON
2. OFF
1. NIL
2. a
3. b
4. c
5. d
6. e
7. f
PENTAX R-300 (p53-64) 10/30/02 11:13 AM Page 61