Enterasys Networks 7H4385-49 Manuel D’Utilisation
Connecting to COM Port for Local Management
DFE-Platinum Series Hardware Installation Guide 3-21
4.
Turn on the PC and set the following parameters on your VT emulation package:
5.
When these parameters are set, the Local Management password screen will display.
Refer to the appropriate Enterasys Matrix DFE‐Platinum Series Configuration Guide for
further information.
Refer to the appropriate Enterasys Matrix DFE‐Platinum Series Configuration Guide for
further information.
Figure 3-9 Connecting an IBM PC or Compatible
Connecting to a VT Series Terminal
To connect a VT Series terminal to an Enterasys Networks DFE module COM port
(
(
), use a UTP straight‐through cable with RJ45 connectors and an RJ45‐to‐DB25
female adapter, and proceed as follows:
1.
Connect the RJ45 connector at one end of the UTP straight‐through cable to the COM
port on the Enterasys Networks module.
port on the Enterasys Networks module.
Parameter
Setting
Mode
7 Bit Control
Transmit
Transmit=9600
Bits Parity
8 Bits, No Parity
Stop Bit
1 Stop Bit
1 UTP straight-through cable
with RJ45 connectors
3 RJ45-to-DB9 PC adapter
2 RJ45 COM port
4 IBM PC or compatible device
CPU
POE
1X
G
R
O
U
P
1
1
OFFLINE/
RESET
COM
MGMT
GROUP
SELECT
GROUP
1
2
3
4
5
6
1
2
3
4
7H4385-49
FAST ENET
Â
Ã
À
Á