Samsung SAMTRON 78E Manuel D’Utilisation

Page de 75
90 ~ 264VAC rms, 60/50 Hz ± 3Hz
Power Consumption
Less than 110 W
Dimensions (WxDxH)
445 x 457.5 x 416mm (After installation of Stand)
Weight
18.2kg
Environmental considerations
Operating
Temperature: 32°F ~ 104°F(0°C ~ 40°C)  
Humidity: 10% ~ 80%, non-condensing
Storage
Temperature: -4°F ~113°F (-20°C ~ 45°C)  
Humidity: 5% ~ 95%, non-condensing
Plug and Play Capability
This monitor can be installed on any Plug & Play compatible system. Interaction of the monitor and 
computer systems will provide the best operating conditions and monitor settings. In most cases, 
monitor installation will proceed automatically, unless the user wishes to select alternate settings.
Note: Design and specifications are subject to change without prior notice.
 
 
 
 
PowerSaver
  
This monitor has a built-in power management system called PowerSaver. This system saves energy 
by switching your monitor into a low-power mode when it has not been used for a certain amount of 
time. The monitor automatically returns to normal operation when you press a key on the keyboard. For 
energy conservation, turn your monitor OFF when it is not needed, or when leaving it unattended for 
long periods. The PowerSaver system operates with a VESA DPMS compliant video card installed in 
your computer. Use a software utility installed on your computer to set up this feature. 
 
State
 
Normal Operation
 
Power-off Mode  
EPA/ENERGY 2000
 
Power Indicator
Green
Green, Blinking 
Power Consumption
Less than 110W
Less than 1W 
 
This monitor is EPA ENERGY STAR
®
 compliant and ENERGY2000 
compliant when used with a computer equipped with VESA DPMS 
functionality. 
As an ENERGY STAR
®
 Partner, SAMSUNG has determined that this 
product meets the ENERGY STAR
®
 guidelines for energy efficiency.
 
 
 
 
Preset Timing Modes
 
If the signal transferred from the computer is the same as the following Preset Timing Modes, the 
screen will be adjusted automatically. However, if the signal differs, the screen may go blank while 
the power LED is on. Refer to the video card manual and adjust the screen as follows.