Intel 815 Manuel D’Utilisation
Intel® 815 Chipset: Graphics Controller PRM, Rev 1.0
R
284
15.4.5.3.
SHEIGHT—Source Height Register
Memory Address Offset:
3Ch (R/W)
On-chip Reg. Mem Addr Offset:
3013Ch (RO; debug path)
Default Value:
00h
Access:
see address offset above
Size:
32 bits
31
26 25
16 15
11 10
0
Reserved
UV Source Height
Reserved
Y/RGB Source Height
Bit Description
31:26
Reserved.
25:16
UV Source Height. In packed formats this is unused. For planar YUV formats it indicates the number
of lines starting at and including the base address line contained in the UV source data. When the last
line is reached and the complete destination window has not been filled, this line will be repeated until
the end of the destination window.
of lines starting at and including the base address line contained in the UV source data. When the last
line is reached and the complete destination window has not been filled, this line will be repeated until
the end of the destination window.
• A height must not be specified for lines that are not on the active display.
• Minimum height is 2 lines or 4 lines for interlaced surfaces (Bob).
15:12
Reserved.
10:0
Y/RGB Source Height. In packed formats this indicates the number of lines starting at and including
the base address line contained in the source data. In planar formats, it is the number of Y lines. This
is used to determine where the end of the source is in the vertical direction to handle the edge effects
related to the vertical filter. When the last line is reached and the complete destination window has not
been filled, this line will be repeated until the end of the destination window.
the base address line contained in the source data. In planar formats, it is the number of Y lines. This
is used to determine where the end of the source is in the vertical direction to handle the edge effects
related to the vertical filter. When the last line is reached and the complete destination window has not
been filled, this line will be repeated until the end of the destination window.
• A height must not be specified for lines that are not on the active display.
• Minimum height is 2 lines or 4 lines for interlaced surfaces (Bob).