RAD Data comm ASM-60 Manuel D’Utilisation
ASM-60 Installation and Operation Manual
Appendix C IR-IP Interface Module
Physical Description
C-3
IR-IP LEDs
IR-IP contains three LEDs, which indicate the module activity. Table C-1 lists the
LEDs functions.
Table C-1. IR-IP LEDs Functions
Name Type
Function
INT
Green LED
ON – LAN integrity is established.
ACT
Yellow LED
Blinks – Transmit/receive activity is detected on the
Ethernet link.
ERR
Red LED
ON – Buffer overflow occurred (during normal operation).
During power-up, provides additional indications,
described below.
During power-up, provides additional indications,
described below.
IR-IP DIP Switch
IR-IP interface module contains a four-section DIP switch, as seen in Figure C-3.
Table C-2 lists the DIP switch functions.
Table C-2 lists the DIP switch functions.
Figure C-3. IR-IP DIP Switch
Table C-2. IR-IP DIP Switch Functions
No Function
Values
Default Setting
1
Enables IR-IP to learn its IP
ON
– IP address learning is enabled
OFF
– IP address learning is disabled
OFF
2
Selects the WAN protocol
ON
– PPP protocol
OFF
– Frame Relay protocol
OFF
3
Selects the LAN mode
ON
– Full duplex operation
OFF
– Half duplex operation
OFF
4
Controls the remote WAN test
loopback, which returns packets
received from the WAN back
loopback, which returns packets
received from the WAN back
toward the WAN
ON
– The test loopback is activated
OFF
– The test loopback is disabled
OFF
Table C-3 provides the pinout of the IR-IP RJ-45 connector.
Table C-3. RJ-45 Pinout
Pin Name
Function
1
TD (+)
Transmit data positive
2
TD (-)
Transmit data negative
3
RD (+)
Receive data positive
6
RD (-)
Receive data negative