Telenetics DSP 9612 Manuel D’Utilisation
Configuring the Modem
Page 13
Configuring the Modem
You configure the modem using the three sets of DIP switches on the
bottom of the modem.
bottom of the modem.
,
IMPORTANT
It is important to follow the three steps described
below, in the order shown, to ensure that you configure
your modem properly using the modem DIP switches:
below, in the order shown, to ensure that you configure
your modem properly using the modem DIP switches:
1. Use DIP switch 3 (SW3) to configure the modem
for your host DTE interface and network topology.
Using SW3, you select the modem to operate in
high-speed fast-poll or low-speed (FSK) mode.
Using SW3, you select the modem to operate in
high-speed fast-poll or low-speed (FSK) mode.
2. If you set SW3 for FSK mode in step 1, use DIP
switch 2 (SW2) to configure the modem for either
Bell 202T or ITU-T V.23 compatibility.
Otherwise, you can use the modem in fallback
mode.
Bell 202T or ITU-T V.23 compatibility.
Otherwise, you can use the modem in fallback
mode.
3. Use DIP switch 1 (SW1) to select the modem’s
transmitter output level and receiver dynamic
range. The SW1 settings apply for both high-speed
fast-poll and low-speed (FSK) modes.
range. The SW1 settings apply for both high-speed
fast-poll and low-speed (FSK) modes.