Telect MIX 56 Manuel D’Utilisation
5 Owner Maintenance
MIX 56 User Manual
5-8
Telect, Inc. 122188-10 A0
R
EPLACING
A
LARM
C
ARDS
ALERT
!
ALERT! To avoid electrostatic discharge, always
wear a grounding strap plugged into the ESD jack
when handling any MIX 56 components.
wear a grounding strap plugged into the ESD jack
when handling any MIX 56 components.
To replace an alarm card, you must remove the LED panel faceplate, which
is held in place by a pin on one side and a screw on the other side. You
must pull the faceplate out at an angle in order to remove it without break-
ing the pin, as described below.
is held in place by a pin on one side and a screw on the other side. You
must pull the faceplate out at an angle in order to remove it without break-
ing the pin, as described below.
Step
Action
1.
Loosen the screw holding the LED panel faceplate in place.
2.
Carefully pull the end with the screw out slightly at an angle.
3.
Pull the faceplate to the side of the chassis to remove its pin from
the hole, and set the faceplate aside.
the hole, and set the faceplate aside.