Enterasys Networks 1G58x-09 Manuel D’Utilisation

Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide

For details on how to enable all router CLI configuration modes, refer back to 

.

For details on configuring routing protocols, refer to 

To enable routing interface configuration mode on the device, to create VLAN or loopback routing 
interfaces, to review the usability status of interfaces configured for IP, to set IP addresses for 
interfaces, and to enable interfaces for IP routing at device startup.

The commands needed to review and configure interface settings are listed below and described in 
the associated section as shown:

show interface

interface (

)

show ip interface (

)

ip address (

no shutdown (

Use this command to display information about all interfaces (VLANs or loopbacks) configured on 
the router.

show interface [vlan vlan-id | loopback loopback-id]

VLAN

vlan vlan-id

Loopback

loopback loopback-id

NOTE: The command prompts used in examples throughout this guide show a system 
where VLAN 1 has been configured for routing. The prompt changes depending on your 
current configuration mode, and the interface types and numbers configured for routing 
on your system.