Enterasys Networks 1G58x-09 Manuel D’Utilisation
Process Overview: Routing Protocol Configuration
Configuring OSPF
13-36
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan <vlan_id>))#
Command Defaults
None.
Example
This example shows how to set the hello interval to 5 for VLAN 1:
13.1.2.10ip ospf dead-interval
Use this command to set the number of seconds a router must wait to receive a hello packet from
its neighbor before determining that the neighbor is out of service.
its neighbor before determining that the neighbor is out of service.
ip ospf dead-interval seconds
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command sets the dead interval value to the default, 40
seconds:
seconds:
no ip ospf dead-interval
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan <vlan_id>))#
Command Defaults
None.
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip ospf hello-interval 5
seconds
Specifies the number of seconds that a router must wait to
receive a hello packet. Dead interval must be the same on
neighboring routers (on a specific subnet), but can vary
between subnets. This parameter is an unsigned integer
ranging from 1 to 65535.
receive a hello packet. Dead interval must be the same on
neighboring routers (on a specific subnet), but can vary
between subnets. This parameter is an unsigned integer
ranging from 1 to 65535.