Hypercom ICE 5000 Manuel D’Utilisation
C h a p t e r 2
Installation Procedures
This section contains inportant information that will help properly install ICE 5000 and 5500 terminals.
Power-Up the ICE Terminals
Use the following procedures to power up the ICE 5000 or 5500 terminals.
Step-by-Step
To power up the ICE terminal:
1.
Connect the +24 Vdc power cable from the AC Adaptor to the three-pin terminal socket labeled
POWER on the back panel of the ICE 5000 or 5500 terminals.
POWER on the back panel of the ICE 5000 or 5500 terminals.
2.
Plug the AC Adaptor into a 110-Volt grounded power receptacle. Be sure the connector is firmly
seated. When the power is connected successfully, the terminal beeps twice and then performs a
self-test and diagnostic routine.
seated. When the power is connected successfully, the terminal beeps twice and then performs a
self-test and diagnostic routine.
Figure 2-1. ICE 5000 power socket
Power socket