Avery 9493 Manuel D’Utilisation
SEt NW INAP [PAP/MSCHAP_V2]
Sets the EAP inner authentication protocol.
SEt NW IROAM [DISable/STRICT/FLEXible]
Controls whether the radio frequencies are set based on the radio configuration or from its access point.
Disabled uses the radio defaults. Flexible uses access point settings if present, otherwise the radio
defaults are used. Strict uses access point regulatory frequency information.
Disabled uses the radio defaults. Flexible uses access point settings if present, otherwise the radio
defaults are used. Strict uses access point regulatory frequency information.
SEt NW KEY# <1/2/3/4>
Sets which WEP key number to use (default is 1).
SEt NW KEYVAL <WEPkey>
Sets WEP key value. Must be hexadecimal.
SEt NW MOde [INfra/ADhoc]
Sets 802.11b/g wireless mode to infrastructure or Ad-Hoc mode.
SEt NW PW <password>
Sets the password for 802.11b/g EAP authentication.
SEt NW REALM <realm>
Sets the realm portion of the 802.11b/g EAP authentication ID.
SEt NW RTS n
Sets the network RTS threshold. Range is 1-3000.
SEt NW REGDOMain <countrycode>
Sets the region of operation for the print server using the following table. The list of supported
countries varies based on the radio type (802.11b or 802.11b/g).
countries varies based on the radio type (802.11b or 802.11b/g).
SEt NW SPeed <1/2/5.5/6/9/11/12/18/24/36/48/54>
Sets 802.11b/g wireless speed in megabits per second (Mpbs).
SEt NW SSid “<ssid>”
Sets 802.11b/g wireless SSID. Use quotes if there is a space in SSID. This is case sensitive.
SH NW STATS
Shows the network I/O statistics.
SEt NW WEP [DIS/64/128]
Sets wired equivalent privacy encryption level to disabled, 64-bit, or 128-bit.
SEt NW WPAGROUP [ENABLE/DISABLE]
Selects whether to use the WPA group key mode. When enabled, group keys are used for data link
encryption.
encryption.
SEt NW WPAPSK <psk-str>
Sets the WPA pre-shared key or pass-phrase. Use 64 hex characters for the PSK or 8-63 characters for
the pass-phrase. This is only valid when authentication mode is WPA-PSK.
the pass-phrase. This is only valid when authentication mode is WPA-PSK.
T C P / I P C o m m a n d s
SEt IP [EN/DIS]
Selects whether to use IP-based protocols.
SEt IP ACcess [EN] aa.bb.cc.dd
[Mask ee.ff.gg.hh]
[Mask ee.ff.gg.hh]
Allows or prevents specified IP address from accessing print server.
SEt IP ADdress
Sets IP address of print server.
SEt IP ARP [EN/DIS]
Selects whether to use an IP address with an ARP packet.
Telnet Console Commands 6-7