Cabletron Systems 9E133-36 Manuel D’Utilisation
2-3
Installing the Modules
Installing EPIMs
This section contains procedures on how to add/replace an Ethernet Port
MicroLAN Module (EPIM). After installing the EPIM, refer to Appendix A to
verify proper EPIM operation.
MicroLAN Module (EPIM). After installing the EPIM, refer to Appendix A to
verify proper EPIM operation.
EPIM Revisions
Revision numbers are located on the EPIM’s Printed Circuit Board directly
following the Part Number as shown in Figure 2-2. Table 2-1 lists the required
board revision for each EPIM.
following the Part Number as shown in Figure 2-2. Table 2-1 lists the required
board revision for each EPIM.
Figure 2-2. Location of Revision Number
Table 2-1. EPIM Board Revisions
EPIM
EPIM BOARD REVISION
EPIM-T
04 or greater
EPIM-F2
05 or greater
EPIM-F1
05 or greater
EPIM-F3
02 or greater
EPIM-C
05 or greater
EPIM-A
Not Applicable
EPIM-X
02 or greater
Observe all static precautions while handling EPIMs.
!
CAUTION
CABLETRON SYSTEMS INC. PN 9000474 - 04
EPIM Board Revision
EPIM-T