Siemens 6ED1050-1AA00-0BE8 Manuel D’Utilisation
Configuring LOGO!
7.1 Selecting parameter assignment mode
LOGO!
290
Manual, 04/2011, A5E03556174-01
7.1.1
Parameters
Note
The following discourse on parameters assumes that the respective default parameter mode
The following discourse on parameters assumes that the respective default parameter mode
("+") has been maintained. This is a prerequisite for viewing and editing parameters in the
parameter assignment mode! See the "Parameter protection (Page 153)" topic and the
Parameters are, for example:
● The delay times of a timer relay
● The switching times (cams) of a timer switch
● Counter thresholds
● The monitoring time for hour counters
● The trigger thresholds
Each one of the parameters is identified by its block number (Bx) and the shortname of the
● The delay times of a timer relay
● The switching times (cams) of a timer switch
● Counter thresholds
● The monitoring time for hour counters
● The trigger thresholds
Each one of the parameters is identified by its block number (Bx) and the shortname of the
parameter. Examples:
● T: ...is a configurable time
● MI: ...is a configurable time interval
● T: ...is a configurable time
● MI: ...is a configurable time interval
Note
LOGO!Soft Comfort also allows you to assign names to blocks (for more information,
LOGO!Soft Comfort also allows you to assign names to blocks (for more information,
refer to the chapter entitled "LOGO! Software (Page 313)".