Blade ICE BMD00098 Manuel D’Utilisation

BMD00098, December 2009

With RADIUS turned on, users might see a duplicate login prompt for SSHv2 clients, if the 
RADIUS server is too slow to respond or if the RADIUS server is not available. In this case, users 
must re-type the username and password to login.

Due to backward-compatibility issues, two Routing Information Protocol (RIP) MIBs are available 
in BLADEOS: 

ripCfg

 and 

rip2Cfg

. Use the 

rip2Cfg

 MIB to configure RIPv1 and RIPv2 

through SNMP. 

BLADEOS does not support the standard RIPv2 MIB, as described in RFC 1724. Use the 

rip2Cfg

 MIB to configure RIPv1 and RIPv2 through SNMP. 

When you create a trunk or link loop between the GbESM and another switch, packets might loop 
infinitely at line rate within the related links. When this problem occurs, the GbESM continuously 
displays the following messages at the console: 

WARNING: packet_sent u: 0, dv_active: tx ring full

packet_sent dcnt=114, public1=110, vcnt=1025

Solution: Remove the loop to resolve this misconfiguration.

Multicast, broadcast and DLF (Destination Lookup Failure, which are unknown destination MAC 
packets) traffic is sent to the lowest numbered port in the trunk. If this port is down, then the traffic 
is sent to the next lowest-numbered port. If the port that was down comes up again, the traffic is not 
re-hashed back to the recovered port.

Some versions of Microsoft Internet Explorer version 6.x do not perform HTTP download 
efficiently. If you have one of these versions, HTTP software download might take much 
longer than expected (up to several minutes).

Web-browsers from different vendors may vary in their support of standard features. If you 
encounter problems using the BBI in a particular browser, a different browser may resolve the 
issue.