Actron 9640A Manuel D’Utilisation

Page de 126
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •  3 – 5
 Using The Scan Tool
Seiko DPU-414
Kodak DICONIX 180si (serial printer model)
Lexmark Model 2480 with optional serial interface (p/n 12T0154)
Panasonic KX-P1131 printer
Cabling
Type: A standard RS-232 type cable.
Scan Tool end: DB9F (female) connector.
Printer end: 
• Use a DB9M (male) connec-tor for the Seiko and 
Kodak printers.
• Use a DB25 male connector for the Lexmark and 
Panasonic printers. 
• If the printer uses a different connector, then an 
adapter or different RS-232 cable is required. 
Adapters are available at most local PC stores or 
electronics outlets.
Serial Port Settings
Default settings for the scan tool are: 9600 Baud, 8 Data Bits, No Parity 
and 1 Stop Bit.
Ensure the settings on the scan tool and printer match.
For the Lexmark and Panasonic printers, ensure the printer’s interface 
selection is set to either “auto” or “serial”.
The printer and scan tool must have the same communication settings. You can 
change the scan tool’s settings if necessary. 
Changing the Printer Settings
Select either Print Codes from the 
Main Menu or Print Data from of the 
Function List and press 
ENTER
Next, the tool will inform you of the 
printer settings (Custom or Default), 
then ask if you wish to change them. 
Select YES and press 
ENTER
.The 
default values are designated on the dis-
play with the word (Default) next to the 
option. 
Refer to the printer manual for the settings. The changes made reside in the tool 
even when the tool is turned off.
Tool settings are as follows. Defaults are in [ . . . ]
Baud Rate: [9,600], 1200, 2400
Stop Bits: [1 Bit], 2 bits
Parity: [None], Odd, Even
Printer Speed: [Fast], Slow
DB9
DB25
Main Menu
|
Vehicle Diagnosis
` Print Codes
[
Tool Setup
Tool Set To Default |
 Printer Settings.
 Change  Settings?
Yes    <No>