Actron 9640A Manuel D’Utilisation
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 6 – 3
Ford Historic Self-Test Routines
6
After viewing and noting the KOEO
codes, use the
codes, use the
DOWN
arrow key to view
Continuous Memory codes.
When done, press
FUNC
to return to
the Ford Function List.
Read KOER Codes
The
Read KOER Codes function activates the KOER (Key-On-Engine-Run-
ning) self-test which retrieves KOER DTCs that are present when the engine
is running.When the trouble condition is inactive, the KOER Code will no longer
be sent through the data stream. This function also performs a
is running.When the trouble condition is inactive, the KOER Code will no longer
be sent through the data stream. This function also performs a
Computed Tim-
ing Check for EEC-IV vehicles manufactured from 1984 through 1991.
The DTCs are transmitted in two formats which transmit the same information:
•
Slow Codes are regular service codes that allow the user to identify the
faults with an analog voltmeter or the check engine light. Slow codes are
transmitted within 3 minutes.
faults with an analog voltmeter or the check engine light. Slow codes are
transmitted within 3 minutes.
Fast Codes are transmitted within seconds and must be read with a diag-
nostic tool. MECS vehicles do not support Fast Codes.
nostic tool. MECS vehicles do not support Fast Codes.
Exhaust gases are harmful or lethal. Always Operate
vehicle in a well-ventilated area.
vehicle in a well-ventilated area.
The KOER test is done with the engine running. Do not
over-rev engine. Observe all safety precautions.
over-rev engine. Observe all safety precautions.
Avoid Cooling Fan! It May Turn On During Test.
Select
Read KOEO Codes from the
Ford Function List
and press
ENTER
.
Fast or Slow Codes
Select
Fast Codes or Slow Codes and
press
ENTER
.
Follow the instructions step-by-step.
Failure to perform these steps may set
a false DTC in the PCM — observe the
display.
Failure to perform these steps may set
a false DTC in the PCM — observe the
display.
1) Set Parking Brake.
2) Transmission In Park Or Neutral.
3) Turn A/C Off.
4) Start Engine — Let Idle Until Hot.
5) Turn Ign Key Off.
6) Wait 10 Seconds. Start Engine — Let Idle.
7) If Vehicle Has A Manual Transmission, Release Clutch.
2) Transmission In Park Or Neutral.
3) Turn A/C Off.
4) Start Engine — Let Idle Until Hot.
5) Turn Ign Key Off.
6) Wait 10 Seconds. Start Engine — Let Idle.
7) If Vehicle Has A Manual Transmission, Release Clutch.
Press
ENTER
to activate the self-test.
✓
The following actions do not apply to MECS vehicles.
❒
For a 7.3L Diesel, depress the throttle until test is done.
Memory Code 126
MAP Sensor Signal
]
Voltage Higher or [
Lower Than Expected~
!
WARNING
!
CAUTION
!
CAUTION
Ford Function List |
1)Read KOEO Codes
` 2)Read KOER Codes [
3)Review Codes
~
Select Code Type
` 1)Fast Codes
2)Slow Codes
3)Computed Timing