GE PDW9900 Manuel D’Utilisation

The stainless steel panels can be cleaned
with CERAMA BRYTE

Stainless Steel

Appliance Cleaner or a similar product
using a clean, soft cloth. 

You can order CERAMA BRYTE

Stainless

Steel Appliance Cleaner through GE Parts
by calling 800.626.2002. (For U.S. only.)

The stainless steel used to make the
dishwasher tub and inner door provides 
the highest reliability available in a GE
dishwasher. If the dishwasher tub or inner
door should be scratched or dented during
normal use, they will not rust or corrode.
These surface blemishes will not affect 
their function or durability.

• Each pad must be touched within 5 minutes of the others. 

To relight, touch any pad again, or unlatch and relatch door.

• Detergent cup opening.

• The motor stopping during the drying period.

• Water draining out of the tub immediately after you touch

START/RESET pad.

• Drying fan running for 2–4 hours after CLEAN light is 

illuminated (Top Control Panel models only).

• Make sure everything is secured in dishwasher.

• Dishwasher has not been used on a regular basis. If you 

do not use your dishwasher often, set it to fill and pump out
once every week. This will help keep the seal moist.

• Reposition the dishes.

• A small amount of clean water around the outlet on the tub

bottom at the back of the tub keeps the water seal lubricated.

• If you have an air gap, clean it. 

• Check to see if your kitchen sink is draining well. If not, 

you may need a plumber.

• If the dishwasher drains into a disposer, run disposer clear.

• Use only automatic dishwasher detergents to avoid sudsing. 

and Electrasol

dishwasher detergents have been 

approved for use in all GE dishwashers.

• To remove suds from the tub, open the dishwasher and let

suds dissipate. Add 1 gallon of cold water to the tub. Pump
out water by starting any cycle and then resetting the unit
after 10 seconds (see About the dishwasher control panel
section). Repeat if necessary.

• Always wipe up rinse agent spills immediately.

16