Jura Capresso ENA 3 Manuel D’Utilisation

1. Open the cover behind the Rotary Dial. (Fig. 1,5)
2. Push and hold the P button (Fig. 4) until the display shows 

.

3. Turn the Rotary Dial until the display show 

4. Push the Rotary Dial. The display shows 

5. Turn the Rotary until the display shows 

✓

6. Push the Rotary dial again to confirm. The display shows 

and then 

7. Remove the Clearyl cartridge from its bag and rinse cartridge

under water.

8. Remove the water tank, open the Clearyl filter holder (Fig. 6) 

and insert the cartridge with its tapered end down into the 
water container. Make sure it fits securely inside the fins. 

9. Push down the Clearyl holder until it snaps in (Fig. 7). 
10. Fill the water tank with fresh cold water and replace.
11. Place a 20 oz. container under the steam nozzle (Fig. 17).
12. Push the Rotary Dial. The display shows 

.

13. Turn the Selector Switch to the hot water/steam position. 

. Approx. 16 oz of cold water is pushed 

through the filter and through the steam nozzle. The rinsing 
water might be slightly discolored. This is not harmful and 
does not affect the taste of your next coffee. The rinsing 
stops automatically. The display shows 

.

14. Turn the Selector Switch back to the coffee position.

.

The filter is now activated.
Please note: As long as the filter is activated, the water
hardness setting is automatically turned off.

17.2 AUTOMATIC CLEARYL REPLACEMENT
Eventually the filter needs to be replaced. Over time and
depending on the amount of water, the filter will cease to work.
The machine cannot monitor the time aspect. It monitors the
water volume. After approx. 60 liters of water use (~2,000 oz.)
the display shows alternating 

1. Open the cover behind the Rotary Dial. (Fig. 1,5)
2. Press the Rinse button (Fig. 4). The display shows 

3. Remove and empty the water tank.
4. Open the filter holder (Fig. 6) and remove the old cartridge.
5. Remove the new Clearyl cartridge from its bag and rinse 

under water.

6. Insert the cartridge with its tapered end down into the water 

container. Make sure it fits securely inside the fins. 

7. Push down the Clearyl holder until it snaps in (Fig. 7). 
8. Fill the water tank with fresh cold water and replace.
9. Place a 20 oz. container under the steam nozzle (Fig. 17).
10. Push the Rotary Dial. The display shows 

.

11. Turn the Selector Switch to the hot water/steam position. 

. Approx. 16 oz of cold water is pushed 

through the filter and through the steam nozzle. The rinsing 
stops automatically. The display shows 

.

12. Turn the Selector Switch back to the coffee position.

. 

.

Important: If the filter is older than two months it needs to be
replaced, regardless how much water has been processed (see
chapter 16.3). At that time the filter has lost its calcium sup-
pressing abilities and calcium will build up inside the machine.

23.