Bunn MCAA Manuel D’Utilisation

17

When disassembling your brewer for cleaning, inspect the sprayhead seal for cracks, 

tears and holes. Although the seal should last for an extended period of time, damage can 

occur through handling. 
CAUTION: The seal confines the hot liquid to the pod holder. Replace the seal if it becomes 

To prevent residue build up, it is a good idea to periodically disassemble the pod 

holder/screen assembly and clean it with a mild detergent.

1)  Press and hold the POD RELEASE BUTTON while sliding the 

pod holder out.

2)  Flip the POD HOLDER upside down and place the holder 

cavity over the palm of your hand.

3)  Using a small object, press the tab of the POD HOLDER 

INSERT through the hole in the bottom of the pod holder to 

remove.

4)  Clean the screen and holder using a mild detergent and rinse. (Dishwasher Safe)

5)  Press the insert back through the hole in the bottom of the POD HOLDER.

If the brewer has not been used for an extended period of time, it is a good idea to 

cycle your brewer before brewing a serving of coffee or tea.

1)  Remove the reservoir and pod holder from the brewer, clean with a mild detergent and 

rinse.

2)  Refill the reservoir to the maximum line.

3)  Insert an empty pod holder into the brewer.

4)  Set the volume control lever to the maximum setting.

5)  Place a container on the drip tray grate that will hold at least

 

 

414 ml (14 oz.)

6)  Press the coffee brew button.

7)  When the brew cycle has ended and water drip out has stopped, carefully remove the 

pod holder and remove any excess water.

Unplug the brewer and wait for it to cool. If your Pod brewer has been used, it must be 

stored above 0°C (32°F) to prevent damage to the internal water tank. Empty and dry the 

water reservoir before storing.
NOTE: Water will remain in the internal tank. If stored for an extended period of time, refer 

P2942