Frymaster SinBaD Series Manuel D’Utilisation

 

 

IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE OR MAINTENANCE CAN CAUSE PROPERTY 
DAMAGE, INJURY, OR DEATH.  READ THE INSTALLATION, OPERATING, AND MAINTENANCE INSTRUCTIONS 
THOROUGHLY BEFORE INSTALLING, OPERATING, OR SERVICING THIS EQUIPMENT.

 

 

 
DO NOT ATTEMPT TO REPAIR OR REPLACE ANY COMPONENT OF THIS EQUIPMENT UNLESS ALL POWER TO THE 
EQUIPMENT HAS BEEN DISCONNECTED.

 

FOR YOUR SAFETY, DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE 
VICINITY OF THIS OR ANY OTHER APPLIANCE.

 

 

 
FRYMASTER EQUIPMENT IS MANUFACTURED FOR USE WITH THE TYPE VOLTAGE SPECIFIED ON THE EQUIPMENT 
RATING PLATE.  FOR PROPER ELECTRICAL INSTALLATION PROCEDURES IN THE UNITED STATES, REFER TO THE 
LATEST EDITION OF THE NATIONAL ELECTRIC CODE (ANSI/N.F.P.A. NO 70).  IN CANADA, REFER TO THE CANADIAN 
ELECTRICAL CODE PART 1 (CSA-22.1.)  FOR INSTALLATION IN COUNTRIES OTHER THAN THE UNITED STATES AND 
CANADA, REFER TO THE NATIONAL CODE APPROPRIATE FOR THE COUNTRY IN WHICH THE EQUIPMENT IS BEING 
INSTALLED.

 

 

 
DO NOT OPERATE THIS EQUIPMENT UNLESS ALL SERVICE AND ACCESS PANELS ARE IN PLACE AND PROPERLY 
SECURED.

 

 

 
This device complies with Part 15 of the FCC rules.  Operation is subject to the following two conditions: 1) This device may 
not cause harmful interference, and 2) This device must accept any interference received, including interference that may 
cause undesired operation.  While this device is a verified Class A device, it has been shown to meet the Class B limits. 
 

This digital apparatus does not exceed the Class A or B limits for radio noise emissions as set out by the 
ICES-003 standard of the Canadian Department of Communications. 
 
Cet appareil numerique n’emet pas de bruits radioelectriques depassany les limites de classe a et b prescrites 
dans la norme NMB-003 edictee par le ministre des communications du Canada. 

HAZARD COMMUNICATION STANDARD (HCS) – WHEN THE PROCEDURES IN THIS MANUAL INCLUDE 
THE USE OF CHEMICAL PRODUCTS, THE PRODUCTS WILL BE PRINTED IN BOLD FACE, FOLLOWED BY 
THE ABBREVIATION HCS IN THE TEXT PORTION OF THE PROCEDURE.  SEE THE HAZARD 
COMMUNICATION STANDARD (HCS) MANUAL FOR THE APPROPRIATE MATERIAL SAFETY DATA SHEET 
(MSDS).