Smeg ALFA135BE Manuel D’Utilisation
Instructions for the Installer
22
In case of connection to the electrical mains by means of socket and pin,
the connection must be completed with a three-pin plug of suitable rating
(25A), or, for operation at 380-415V2N
the connection must be completed with a three-pin plug of suitable rating
(25A), or, for operation at 380-415V2N
∼
or 380-415V3N
∼
, a five-pin plug
(16A). The power supply plug and wall socket must be of the same type
(in compliance with CEI standards). Check that the power supply line is
properly earthed. The use of reductions, adapters or junctions is not
recommended.
(in compliance with CEI standards). Check that the power supply line is
properly earthed. The use of reductions, adapters or junctions is not
recommended.
If a permanent connection to the elctrical mains is used, the appliance's
power supply line must be fitted with an omnipolar breaking device with
contact breaking gap of at least 3 mm, located in an easily accessible
position close to the appliance itself.
power supply line must be fitted with an omnipolar breaking device with
contact breaking gap of at least 3 mm, located in an easily accessible
position close to the appliance itself.
WARNING: if the mains voltage drops below 190 VAC there might be
an impairment of the oven's performance; this is not due to the
an impairment of the oven's performance; this is not due to the
appliance itself.
2.1.1
Safety thermostat
The oven is fitted with a safety device tripped in case of a serious
malfunction. To reset the safety device, call the after-sales service.
malfunction. To reset the safety device, call the after-sales service.
The manufacturer declines all responsibility for injury or damage
caused by failure to comply with the above regulations or deriving from
tampering with even just one part of the appliance.
caused by failure to comply with the above regulations or deriving from
tampering with even just one part of the appliance.
2.2 Levelling
Level the oven by means of its four adjustable feet. To make the
adjustment, undo the lock-nut and unscrew the foot. The adjuster screw
travel is 10 mm.
adjustment, undo the lock-nut and unscrew the foot. The adjuster screw
travel is 10 mm.
2.3 Steam vent pipes
Depending on the model, the back of
the oven is fitted with two pipes
which vent the steam produced
during cooking. These pipes must
be left free of all obstructions. Take
care not to crush them.
the oven is fitted with two pipes
which vent the steam produced
during cooking. These pipes must
be left free of all obstructions. Take
care not to crush them.