Sony 2 Manuel D’Utilisation
269
Setup Relating to DCU
Ch
apt
apt
er 16
E
ngin
eering Se
tup
3
To apply the selection made in step
2
when the input is the GPI high level,
press [H Set]. To apply the selection made in step
2
when the input is low,
press [L Set].
This confirms the setting, which appears in the status area.
Parallel Output Settings (Output Config Menu)
For the DCU parallel output ports, after carrying out tally settings in the
Router/Tally>Tally Enable menu, you can assign GPI outputs to output ports
that are still unused.
To assign DCU outputs to DCU parallel output ports, display the DCU>Output
Config menu.
Router/Tally>Tally Enable menu, you can assign GPI outputs to output ports
that are still unused.
To assign DCU outputs to DCU parallel output ports, display the DCU>Output
Config menu.
To display the Output Config menu
In Engineering Setup, select VF5 ‘DCU’ and HF3 ‘Output Config.’
The status area shows output port information.
The status area shows output port information.
Assigning a GPI output port
Use the following procedure.
1
In the DCU>Output Config menu, select what the setting applies to (DCU1
or DCU2) from the <DCU Select> group.
or DCU2) from the <DCU Select> group.
2
In the <Parallel Output Assign> group, press [GPI Output].
3
Using any of the following methods, select the output port and GPI output
number.
number.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the setting.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the setting.
Knob
Parameter
Adjustment
Setting values
1
No
Signal format/screen aspect ratio
selection
selection
1 to ...
Knob
Parameter
Adjustment
Setting values
1
Parallel Output Slot
Output port slot
2 to 6
2
Parallel Output Port
Output port
1 to 54
5
GPI Output
GPI output
1 to 50