D-Link DWC-1000 Manuel D’Utilisation
Wireless Controller
User Manual
35
Chapter 3. Connecting to the Internet:
WAN Setup
This contoller has two WAN ports that can be used to establish a connection to the
internet. The following ISP connection types are supported: DHCP, Static, PPPoE,
PPTP, L2TP (via USB modem).
internet. The following ISP connection types are supported: DHCP, Static, PPPoE,
PPTP, L2TP (via USB modem).
It is assumed that you have arranged for internet service with your Internet Service
Provider (ISP). Please contact your ISP or network administrator for the configuration
information that will be required to setup the controller.
Provider (ISP). Please contact your ISP or network administrator for the configuration
information that will be required to setup the controller.
3.1 Internet Setup Wizard
Setup > Wizard > Internet
The Internet Connection Setup Wizard is available for users new to networking. By
going through a few straightforward configuration pages you can take the information
provided by your ISP to get your WAN connection up and enable internet access for
your network.
going through a few straightforward configuration pages you can take the information
provided by your ISP to get your WAN connection up and enable internet access for
your network.
Figure 16 : Inter net Connectio n Set up W izar d
You can start using the Wizard by logging in with the administrator password for the
controller. Once authenticated set the t ime zone that you are located in, and then
choose the type of ISP connection type: DHCP, Static, PPPoE, PPTP, L2TP.
Depending on the connection type a username/password may be required to register
this controller with the ISP. In most cases the default set tings can be used if the ISP
did not specify that parameter. The last step in the Wizard is to click the Connect
controller. Once authenticated set the t ime zone that you are located in, and then
choose the type of ISP connection type: DHCP, Static, PPPoE, PPTP, L2TP.
Depending on the connection type a username/password may be required to register
this controller with the ISP. In most cases the default set tings can be used if the ISP
did not specify that parameter. The last step in the Wizard is to click the Connect