TomTom GO 740 LIVE 1CF7.014.03 Manuel D’Utilisation

3

Before you start

Install your TomTom GO navigation device in your car following the 

instructions in the installation section at the start of this book.

To switch on your navigation device, press and hold the On/Off button until 

you see the start-up screen. The first time you switch on your device, it may 

take a short time to start.

To set up your device you need to answer a few questions by tapping the 

screen.

In rare cases, your TomTom GO navigation device may not start correctly or 

may stop responding to your taps.

First, check that the battery is properly charged. To charge the battery, 

connect your device to the car charger. It can take up to 2 hours to fully charge 

the battery.

If this does not solve the problem, you can reset the device. To do this, press 

and hold the On/Off button for fifteen seconds and release the button when 

your device begins to restart.

The battery in your TomTom GO navigation device charges when you connect 

it to the car charger or to your computer.

The light next to the On/Off button is orange while the battery is charging and 

is green when the battery is fully charged.

When you connect your device to a computer, you are asked if you want to 

connect to the computer. If you select No and then do not tap the screen 

within three minutes, the device will automatically switch off. This happens so 

that the battery can charge faster.

Use the Active Dock to install your TomTom GO inside your car.

Make sure that both the Active Dock and your windscreen are clean and dry 

before you attach the holder. Place the Active Dock so that it does not interfere 

with your view of the road or of any of the controls in your car.