Vermont Casting BREF30 Manuel D’Utilisation

7

to installing the unit.
Connect the wall-mounted switch to the fireplace by 

running grounded 3-conductor wire (

MIN

. 14 AWG) to 

the switch from the junction box on the side of the unit.
1.  Locate the voltage selection switch under the logset 

on the left front corner of the unit.

2.  Move the switch from the 120 Volt to the 240 Volt 

position.

3.  Loosen the screws securing the junction box cover, 

and remove the cover.

4.  Remove knockouts in the box cover to use a cable 

clamp.

5.  Pull out three (3) wires:  black, red, and white.
6.  Connect one (1) wire (black) from the wall switch to 

the L1 (black) wire on the unit, and the other wire 
from the wall switch to the L1 (black) wire on the 
power supply. 

7.  Connect one (1) of the wires from the wall switch to 

the L2 (red) wire on the unit, and the other wire from 
the wall switch to the L2 (red) wire on the power sup-
ply. 

8.  Connect the white wire from the unit to the neutral 

(white) wire on the power supply.

9.  Connect the ground wire from the wall switch to the 

wire grouping from the power supply and ground 
stud in the junction box.

10. Ensure all connections are tight. Insert all wiring 

inside the junction box and secure the cover.

7.  Connect the white wire from the unit to the neutral 

(white) wire on the power supply.

8.  Connect the ground wire from the wall switch to the 

wire grouping from the power supply and the ground 
stud in the junction box.

9.  Make sure the red wire (L2) in the junction box has a 

closed end splice or a wire nut properly applied.

10.Ensure all connections are tight. Insert all wiring 

inside the junction box and secure the cover.

clockwise to the highest set point temperature.
Connect the wall-mounted thermostat to the fireplace 

by running a grounded 2-conductor wire (min. 14 AWG) 

to the thermostat from the junction box on the side of 

the unit.
1.  Loosen the screws securing the junction box cover 

and remove the cover. 

2.  Remove knockouts in the box cover to use a cable 

clamp.

3.  Pull out the two (2) brown wires with the closed end 

splice at the end.

4.  Cut off the closed end splice, separate the two wires, 

and strip approximately 5/8" (15mm).

5.  Connect one (1) wire from the thermostat to one (1) 

of the brown wires; connect the other wire from the 
thermostat to the other brown wire.

6.  Connect the ground wire from the wall thermostat to 

the power supply wire group and the ground stud in 
the junction box.

7.  Ensure all connections are tight. Insert all wiring into 

the junction box and secure the cover.