Jacuzzi J-345 Manuel D’Utilisation

58

 

EXISTS AND EQUIPMENT DAMAGE! Never install or 

remove electrical devices (e.g. Apple device/MP3/USB/AUX/

Bluetooth) while hands are wet or while sitting partially or fully 

immersed in the spa!

CAUTION: Never leave electrical devices in the Media Locker 

when spa is not is use to prevent damage from outdoor ele-

ments! Never spray Media Locker with a pressurized water 

hose for any reason! Damage to the device or spa stereo 

system caused by water intrusion is not covered under the 

manufacturer's warranty! Damage to Media Locker port or 

electrical devices due to excessive force or improper align-

ment during installation or removal from Media Locker is not 

covered under warranty.

In order for the remote to operate the stereo, you  

need to pair them using the following method:

1.  Make sure the stereo unit is in "Standby" mode. 

LED power light will be red, Figure A.

2.  Press any button on the remote to turn it ON. 

The remote LCD display will read “No Link.”

3.  Press and hold the “Mode” button on the remote (Figure B). 

At the same time, press and hold the power button on the 

stereo for 2 seconds (Figure A).

4.  The remote LCD display will read “Welcome,” “Load” and 

“Radio” if the pairing sequence was successful.

The Audio button, Figure C, provides access to many of the ste-

reo’s settings. By continually pressing the Audio button you can 

scroll and adjust the following functions: BAS-TRE-BAL-FAD-

DSP-AREA-LOUD-DX-STEREO (respectively).

Note: You can adjust the settings by pressing the Audio button, 

making your adjustments and pressing the Audio button to go 

the next feature. If you exit the setting menus continually press 

the Audio button until you reach the setting you would like to 

adjust.

1.  Bass Setting: Press the Audio button once to access the 

bass setting. The LCD display will change to “BAS 0,” 

Figure D. Press the Up button to adjust the setting to a 

maximum of +5. Press the Down button to adjust the setting down to 

-5.

Note: The default setting is “0.” This feature is disabled when a “Digital 

Sound Processor” (DSP) setting is active such as “Rock,” “Classic,” or 

“Pop.”

Figure A

Figure B

Figure C

Figure D