Jacuzzi J-345 Manuel D’Utilisation

2

This spa was manufactured to meet the standards and specifications 

outlined in the “Virginia Graeme Baker Pool and Spa Safety Act” (VGB 

Safety Act). When installing and using this spa, basic safety precautions 

should always be followed, including:

1.

!

•  Extreme caution must be exercised to prevent unauthorized access 

by children.

•  To avoid accidents, ensure that children do not use this spa unless 

supervised at all times. Adult supervision is a critical safety factor in 

preventing children from drowning.

•  Use the straps and clip tie downs to secure the spa cover when not 

in use. This will help discourage unsupervised children from entering 

the spa. Keep the spa cover secure in high-wind conditions. 

•  There is no representation that the cover, clip tie-downs, or actual 

locks will prevent access to the spa.

2.

!

•  Keep hair, loose articles of clothing or hanging jewelry away from 

suction fittings, rotating jets or other moving components to avoid 

entrapment that could lead to drowning or severe injury.

•  Never use the spa unless all suction guards, filter, filter lid, or 

skimmer assembly are installed to prevent body and/or hair 

entrapment.

•  Never operate or use the spa if the filter, filter lid, or skimmer 

assembly are broken or any part of the skimmer assembly is missing. 

Please contact your dealer or nearest service center for service.

•  The suction fittings and suction covers in this spa are sized to match 

the specific water flow created by the pump(s). If it is necessary to 

replace the suction fittings, suction covers or pump(s), be sure that 

the flow rates are compatible and are in compliance with the VGB 

Safety Act.

•  Never replace a suction fitting or suction cover with one rated less 

than the flow rate marked on the original suction fitting. Using 

improper suction fittings or suction covers can create a body or hair 

suction entrapment hazard that may lead to drowning or severe 

injury.

3.

!

•  Install the spa at least 5 feet (1.5m), from all metal surfaces. As an 

alternative, a spa may be installed within 5 feet of metal surfaces 

if each metal surface is permanently connected (bonded) by a 

minimum No. 8 AWG (8.4 mm²) solid copper conductor attached 

to the wire connector on the grounding lug, inside the equipment 

compartment on the equipment box.