Mitsubishi WS-55517 Manuel D’Utilisation

Select the TV input that you used when you connected 
the video or S-Video cables.  Select the input you used 
when you connected the stereo audio cables, either TV or 

A/V Receiver .  The TV will learn the input names for the 

TV Input and A/V Receiver Input selections.  If your  

A/V Receiver has other inputs than those listed in 

the menu, those other inputs are not available for 
NetCommand. 

 

    

 

 

 

 

 

 

 

 

The playback and record control of some DV camcorders 

may still operate by the IEEE 1394 cable automatically, 

even though you must use the video or S-video cable for 
the picture.  In this case, when you select the camcorder, 
be sure to select analog (not digital) from the pop up when 
a camcorder is selected from the Device Selection menu.  

Then the picture is shown via the analog connection but 

control is from IEEE 1394.

If the new IEEE 1394 device is also connected using 
analog inputs, you will need to define the device type.  
Select the type of device, such as a VCR. Once the device 
type is selected, then the Device screen is displayed so 
the manufacturer can be selected. If the manufacturer 
is listed, then you may be able to control this device 
while it is operating as an analog VCR.  For example, if 
the IEEE 1394 device you have added is a Mitsubishi 
DVCR, and you have selected an analog connection as 
a second connection, then you will select Mitsubishi for 
the manufacturer.  If the manufacturer is not listed, select 

“Other” and use the Learn screens.  

Be sure to place an IR Emitter in front of the remote 
control sensor, just as you have done for other 
NetCommand® devices.  It is necessary to use the IR 
Emitter only when the DVCR is being used as an S-VHS 
or VHS VCR.  When the DVCR is playing or recording 
digital signals in D-VHS, the TV will control the VCR 
through the IEEE 1394 cable.  

To finalize your selections and complete the 

NetCommand setup, select Finish from the Finish 
screen.