Rackmount cv-1602 Manuel D’Utilisation

i. 

Make sure the power adapter plugged into the KVM Switch, if the LED’s still off, perform soft  

 

 

reset to KVM switch.

 

ii. 

Power cycle KVM switch.

Switching to another port and checking if this port has the same problem

a. 

If you switch to another port, please check the screen resolution is the same.

 

b.  

Check the OSD menu is available on the hot keys “Scroll lock + Scroll lock + space bar”. 

 

 

If the problems persist, please make sure the cables are inserted properly and the boot up 

  sequence 

is 

followed.

i. 

Check the server by using a different keyboard and mouse.

 

ii. 

For PS/2 servers

 

 

The keyboard and mouse are not hot pluggable.

 

iii. 

For USB servers

Unplug and plug allowing a few seconds for the bus emulation process to complete.

 

iv 

Do not press any keys on the keyboard whilst the server is booting up. This can cause a    

 

 

keyboard error or cause the keyboard not to detect the KVM switch.

 

v. 

Try a different keyboard, but use only 101/102/104-key keyboard

 

vi. 

Avoid moving the mouse whilst switching the KVM ports.

The LED on the Cat5 dongle will fl ash when plugged into the USB or USB server. The light will then  

 

become steady when the KVM switch has connected. If the LED light is on and not fl ashing when  

             plugged into server, please unplug the USB or PS/2 and try again. Or try another good Cat5 dongle
             to verify if problem still appears. If the problem persists, please contact your supplier.