ASKProxima impression 1280 Mode D'Emploi
USER GUIDE
SXGA LCD PROJECTOR
36
13.2
LAMP REPLACEMENT
The projector is using a metal halide lamp for illumination. The lamp is
high pressure when hot (operating or immediately after switch-off). Lamp
pressure is normal when cold.
high pressure when hot (operating or immediately after switch-off). Lamp
pressure is normal when cold.
A lamp timer is available in the menu system under HELP, ABOUT, that
may be used to track lamp operating time. The timer may be reset by the
user.
may be used to track lamp operating time. The timer may be reset by the
user.
A warning will appear when the estimated lamp lifetime has
been exceeded. Please make sure to replace the lamp when
this message is displayed.
been exceeded. Please make sure to replace the lamp when
this message is displayed.
To change lamp, unscrew the two screws holding the lamp lid. A safety
switch will cut off the power supply to the lamp completely when you
remove the lid. Unscrew the two screws holding the rear wall, including the
reflector, of the lamp house.
switch will cut off the power supply to the lamp completely when you
remove the lid. Unscrew the two screws holding the rear wall, including the
reflector, of the lamp house.
Do not touch any parts of the new lamp with your bare hands.
Wear cotton gloves or use the lamp’s plastic wrapping to
prevent any fingerprints on the lamp in order to assure high
quality brightness.
Wear cotton gloves or use the lamp’s plastic wrapping to
prevent any fingerprints on the lamp in order to assure high
quality brightness.
Screw
Screw
Lamp lid
Projector seen from behind