Affirmative 7370 Mode D'Emploi
Defines the power level at which your client adapter transmits. This value must not be
higher than that allowed by your country's regulatory agency (FCC in the U.S., DOC in
Canada, ETSI in Europe, MKK in Japan, etc.).
higher than that allowed by your country's regulatory agency (FCC in the U.S., DOC in
Canada, ETSI in Europe, MKK in Japan, etc.).
Options: Dependent on the power table programmed into the client adapter; see the
table below
table below
Default: Max (the maximum level programmed into the client adapter and allowed by
your country's regulatory agency)
your country's regulatory agency)
Power Levels
Client Adapter Type
Max, 100 mW,
50 mW,
30 mW, 20
mW, 5 mW, or
1 mW
50 mW,
30 mW, 20
mW, 5 mW, or
1 mW
350 series PC and LM cards
Transmit
Power
Power
Note: Reducing the transmit power level conserves battery power but decreases radio
range.
range.
Note: When World Mode is enabled, the client adapter is limited to the maximum
transmit power level allowed by the country of operation's regulatory agency.
transmit power level allowed by the country of operation's regulatory agency.
NOTE: Before doing a power-off/Cold Boot, you must save all your new settings by executing a
Registries Save/Restore from the Control Panel.
Registries Save/Restore from the Control Panel.
Using Static WEP Keys
1. Go to WEP in the Property box.
2. Select the value Static WEP Keys.
3. Click on the WEP Keys button. The WEP Keys screen, similar to the following screen, will
2. Select the value Static WEP Keys.
3. Click on the WEP Keys button. The WEP Keys screen, similar to the following screen, will
appear.
4. A checkmark appears in the Already Set? box for all existing static WEP keys. Note: For security
reasons, the codes for existing static WEP keys do not appear on the screen.
15