Affirmative 7380 Mode D'Emploi

YEStablet 7380 User’s Guide                                                                                                             September 16, 2003 

 

To turn the YEStablet 7380 on, push and quickly release the power switch to the right of the front 
bezel.  The power LED on the YEStablet 7380 will then turn green indicating that the YEStablet 7380 
is ready to use.  To turn the YEStablet 7380 off, push and hold the power switch for about 4 seconds: 
the power light and display will go off.  A beep will also sound.  You can also use soft controls for 
Power mode and Sleep mode access – use the “Device Shut Down” icon on the TaskBar. 
 

1.  Turn on the power, and after several seconds the Windows CE desktop will be displayed. 
2.  Choose from any of the displayed icons to activate the corresponding application. 
 

1.  The Calibration Properties screen will appear next if this is a new or reset device.  When the 

YEStablet 7380 prompts you to calibrate the touchscreen, use the Stylus (stored in the upper 
right surface of the YEStablet 7380) and tap where indicated on the touchscreen in accordance 
with the instructions.   
(This document refers to “clicking” or “tapping” interchangeably.  The latter is applicable 
when the touchscreen is utilized). 

 
NOTE: You can recalibrate at anytime using either: 
 (1) 

“Start”   “Setting”   “Control Panel”   “Stylus” or 

 (2) 

Pressing 

the 

Soft Keyboard and E-mail buttons at the same time. 

 

1. Click “Start” on the Windows CE Taskbar, select “Settings”, and then click on “Control panel”. 
2.  The Control Panel displays several icons associated with utilities for configuring the YEStablet 

7380. Many of these are self-explanatory. Some major ones are discussed below. 
a)  Display Quality set up 

i)  Click on “Display”.  The Display Properties window will appear.  
ii)  You can use “Brightness” to adjust the brightness of the displayed images.  Tap on the left 

arrow to set the display darker or on the right arrow to increase the brightness. 

i)  Double-click on the “Network” icon. 
ii)  Click on “Network”; the Network Configuration will appear. 
iii) Click on “Adapters”; a list of the network drivers installed on your device will be 

displayed.  Select the adapter that you currently use, then click on “Properties”. 

iv)  You have two options: “Obtain an IP address via DHCP” or “Specify an IP address”. 
v)  When you select “Obtain an IP address via DHCP”, an IP address can be automatically 

assigned to this device if you have a DHCP server in your network.  Then click on “OK” at 
the top of the window for confirmation. 

vi)  When you select “Specify an IP address”; you have to ask your network administrator for 

an address and type it in the space provided (IP Address, Subnet Mask, and Default 

4